Remove Jeep Doors With Power Windows

Lift the door straight up to disconnect it from the jeep.

Remove jeep doors with power windows.

Roll down the windows remove the door check arm unplug the wiring drop the two hinge bolts pull off the limit strap and lift it free. Be careful not to damage the paint. Simple 3 wire hookup. Remove the nuts on the bottom of each bolt.

Once you ve removed the nuts reach through the open window to grip the inside door handle. Try putting the nuts on but just a couple turns and put a wrench on the nut and hit it the wrench with a rubber hammer and when you get the doors off put some bearing grease on the hinge and that will keep them lubed and easier to remove next time but remember to clean and regrease often. The process is basically the same for the front and rear. Heavy duty connectors are installed allowing doors to be removed.

This can be done with a t50 socket and ratchet. See more information on our jeep wrangler power window kit power door lock kits. Lift the door straight up to disconnect it. Use a 13 mm socket and turn counter clockwise to loosen the nuts.

It s also beneficial to lube the door stems and hinges when the doors are removed in order to make future removal easier. Instructions 1 remove the door panel. One power wire goes to the battery one goes to an ignition power source and the third gets grounded in the kick panel. The nuts are painted to match the body of the jeep so be very.

3 on a manual window use the crank to roll down the window halfway to give you access to the bolt that. Removing the doors 1. Be careful with the paint on the door hardware. With the other hand grip the outside door handle.

If you need more information on how to do that check out the door panel removal video.