Slide the cosmetic faceplate away from the door.
Remove old door handle without screws.
Locate the hole underneath the doorknob shaft.
Apply a bit of pressure to the paper clip to trigger a release button inside the hardware.
You should see a tiny slot or hole.
After applying some pressure you can pull the door knob towards you.
Push the tip of a narrow screwdriver into the hole.
If playback doesn t begin.
Insert the tip of a screwdriver and pry off the trim piece.
There should be a small latch near the base of the knob or handle probably on the exterior side of the door.
Our quick video shows you how si.
This is a simple straig.
If not rotate the faceplate until the underlying screws are accessible and use a phillips head screwdriver to remove them.
Once triggered the lever or lock trim can be removed from the door.
Straighten a paper clip and insert it into the hole.
Tug on the knob and it will slide right off.
If any screws are exposed during this process remove them to release the lock and remove it from the door.
With some pressure you can move the clip inside.
Old flat head screws that have been attached for close to a century can be tortuously difficult to remove.
Depending on the door handle design the faceplate may be able to slide completely off.
Last week i talked about how to remove paint from hardware so in keeping with that theme i wanted to discuss some tips to remove stubborn screws.
Push this latch in and pull the handle off the door.
To remove a door handle without any visible screws start by prying off the cover plate by inserting a flathead screwdriver in the notch on the side of the plate.
After all you can t restore old hardware unless you can first get it off the door or window it s attached to.
You would be surprised how a simple job like removing a door handle or doorknob can be a frustrating experience if your not prepared.
Many door knobs have trim plates that cover the screws so removing them can be a bit tricky if you ve never done it before.
Take your flat philips screwdriver and place it in the gap.
How to remove door knob without screws look for the tiny gap on the side of the door knob.
If the knob has a recessed setscrew turn the setscrew counterclockwise with a correctly sized.
Look for a thin slot or a recessed hex head setscrew on the lock side of the doorknob.
