Remove Water From Gas Tank Mower

The principle behind pouring alcohol in the gas tank is as follows.

Remove water from gas tank mower.

Move the mower into the shade or bring it indoors and then shine the flashlight into the tank. Seal the can after all the gas has been removed from the mower. Remove the water from gas tank. This may seem like an expensive alternative to some drivers.

The gas tank on briggs stratton lawn mower engine is made of a non corrosive or corrosion resistant material to shield it from the deteriorating properties of ethanol salt and water. Direct the used gas into a gas can. Heet is a fuel additive that is made for removing water from the gas tank. Water trapped inside a lawnmower will bring it to an immediate standstill.

Water forms globules in the gasoline and these are usually visible they look like bubbles. The water gas and alcohol are then burned up and eliminated from the tank. Gas that s been in the mower for more than a couple of months can go bad with sediment varnish like contaminants and condensation that can make it difficult to even start the mower again when the time comes. Moisture usually gets trapped in the gas tank and from there enters the carburetor bowl.

Water logging typically occurs when lawnmowers sit outside where they are exposed to rain or when you do not screw caps back on. If there s water in the fuel it will bead up. However the damage that you will be avoiding to your car is more than worth it. When alcohol is added to a gas tank with water and gasoline in it the alcohol sinks to the bottom and absorbs the water forming a combination that is no longer harmful to your car s engine.

If you aren t sure loosen the fuel line and let a few drops of fuel drip onto a scrap piece of wood or metal. However if there is more water in the. The best way to remove all water from the gas tank is to drain and refill your gas tank.